Some old gui not sent to the "ucinewgame" command, in this case so that the engine has no problems in starting a new game it is necessary to select in the configuration the parameter "GUI Has Ucinewgame Command". Anyway, I recommend restarting the engine or start a new game to be sure that the changes are made correctly. #POCKET PC CHESS UPDATE#The update of the values of the parameters usually is instant, except in the case of Arena. With the uci protocol not exists a configuration file, normally the parameters of configuration normally is modified within the own interface. In Windows we can use uci version for example on Fritz, Shredder, chessGUI or Arena, In Linux with Arena and in Android on any interface that supports engines. The configuration of the engine in uci mode is similar to xboard mode, we will have to indicate to the GUI the file and the protocol used if this is asked. Important: for changing these parameters is necessary save the file and start or restart the engine, since otherwise the engine does not know changes.ĭanaSah and DanaSah LimitStrength configuration with uci Protocol These parameters are explained later in this document. #POCKET PC CHESS INSTALL#On Windows we can use Winboard, Arena, ChessGUI or even Chessmaster GUI, on Linux we can use Arena and Xboard, on Android we can use Chess for Android but in this case it is recommended to use the UCI version in order to install the engine in the favorite folder and not a given and thus not depend on the configuration file.Įngine will start with a series of parameters by default, these parameters may be changed with the help of Notepad or an editor by opening the "danacfg.txt" configuration file located in the same folder as the executable. If there is a problem you can add the command xboard. To configure the engine, we select in GUI during intallation the necessary file depending on the operating system that you use (for example "danasah_.exe" in Windows), the same file used for the xboard and uci protocol, only you have to indicate to the GUI the protocol which we will use. DanaSah and DanaSah LimitStrength configuration with xboard Protocol
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |